TPC-100 Prism Clone

TPC-100 Prism Clone

The TPC-100 began as an effort to replicate the legacy Texar Audio Prism by simplifying the design using more modern digital methods rather than discrete ICs. Due to obsolescence of parts originally used in the analog prisms and the effort required to re-align them to their original specs, a different approach was taken.  The technology does not use DSP to re-process the audio, but rather uses PWM for gain control keeping the digital logic and control separate as in the original design. 


An analysis of the performance of this unit on a selection with high dynamic range can be found here:  http://www.ortelligent.com/Sting_Little_Wing_Stats_Original_v_Texar_Comp_Clone.gif


Boards and supplies for the TPC-100 Texar Prism Clone audio processor are listed below. The full board set is required for a two channel TPC-100 or individual boards can be purchased for a single channel version. 

User Manual:   http://www.ortelligent.com/TPC100%20Manual%20Rev%20A.pdf


******* Due to the global chip shortage and supply issues if stock shows as zero or "pre-order", please inquire as we may have stock of some parts while awaiting shipment of others. We can give an estimate of availability. 



TPC-100 Full Board Set

TPC-100 Full Board Set

This is the complete 4 PCB set needed to build a two channel TPC-100 as outlined in the build guide...

$208.00 Ex Tax: $208.00

BP-1 Band Processor

BP-1 Band Processor

The BP-1 is a 4 frequency band compressor board used in the TPC-100 Prism Clone.  The board is ..

$62.00 Ex Tax: $62.00

MB-1 IO Board

MB-1 IO Board

The MB-1 IO board is used in the TPC-100 Prism Clone to convert +4dBu studio level balanced audio to..

$20.00 Ex Tax: $20.00

DS-1 Display Board

DS-1 Display Board

The DS-1 display board is used in the TPC-100 Prism Clone to display the expand/compress level and t..

$32.00 Ex Tax: $32.00

Showing 1 to 4 of 4 (1 Pages)